Project Layout
Microtunneling projects should be laid out with attention to the benefits and constraints unique to this construction process. The following recommendations address some of these concerns:...
Shaft Considerations
Jacking and receiving shaft locations should be selected to minimize the number of shafts and disruptions while not exceeding the practical limits of the drive lengths achievable for a...
Shafts/Temporary Structures
Shafts should be of a size to accommodate the equipment and pipe selected and to allow for safe working practices. If the shaft must accommodate the permanent works, it is the contractor's...
Mechanisms Controlling the Permeability of Clays
Coefficients of permeability, calculated using Terzaghi's theory of one-dimensional consolidation, are reported for smectite, illite, and kaolinite, in water, methyl and ethyl...
Size and Scale Effects on the Shear Strength of Concrete Beams
This paper identifies and discusses the role of proper geometric scale of relevant parameters in the size effect in shear, particularly in terms of practical beam design. In the overall...
Non-Destructive Strength Evaluation of a Continuous, Reinforced Concrete Slab Bridge
In the state of New Mexico, a significant number of reinforced concrete slab (RCS) bridges provide service on interstate highways I-10, I-25, and I-40 that are subjected to large amounts...
Application of TOPNET in the Distributed Model Intercomparison Project (DMIP)
This paper describes the application of a networked version of TOPMODEL, TOPNET, as part of the Distributed Model Intercomparison Project, DMIP. The model implementation is based on a...
San Diego Delivers
To maintain its ability to provide water to some of its rapidly growing regions, the city of San Diego is simultaneously laying two large diameter pipelines, one carrying potable water...
Nonlocal Integral Formulations of Plasticity and Damage: Survey of Progress
Modeling of the evolution of distributed damage such as microcracking, void formation, and softening frictional slip necessitates strain-softening constitutive models. The nonlocal continuum...
Impact of Chemically-Induced Clay Transport and Deposition on the Hydraulic Conductivity of a Natural Sand
The purpose of this paper is to understand in part the dynamic impact of surfactants on hydraulic conductivity for designing enhanced pump and treat operations. This paper has two aims:...
Design Live Loads for Parking Garages
The objective of this research project is to obtain a better understanding of parking garage live loads and to recommend an appropriate value for design. A load survey was conducted in...
Microtunneling under Honolulu
Highly congested urban utility corridors present some of the most difficult conditions for construction of new underground pipelines, especially when subsurface conditions are also very...
Order Amid Uncertainty (Available in Geoenvironmental special issue only)
Bayesian statistical methods allow engineers to deduce probabilities from incomplete information. If there is a theoretical or empirical reason why a particular probability distribution...
Basin Response Time: Potential Hydrologic Basin Handprint
Hydrologic lead time is an important factor in many water resources engineering applications. The determination of the response time of a watershed to runoff-producing rainfall is the...
Comparison of Complete Modeling/Simplified Modeling of Zaragoza City Water Supply Network
(No paper) Zaragoza is a Spanish city with 600.000 inhabitants and a water supply network of 900km long. The Council technical services uses a Microstation based GIS, GRED, for network...
Securing the Stone
To prevent spalling at edges on thin stone veneer, engineers who design stone cladding pay special attention to the connection details. Kerf clips, 100-150 mm long, that distribute load...
Potential Microbial Impacts on Groundwater Quality
Over the last decade there has been significant progress in the understanding of sub-surface microbiology. The ubiquity of microorganisms within groundwaters forms a major part of these...
Evaluation of Sampling Properties of General Extreme Value (GEV) Distribution-L-Moments Vs Conventional Moments
The sample estimates of conventional moments are shown to be biased and this bias increases for small samples, and especially so when the skewness is high (Wallis et al., 1974). The recently...
FLODRO 2.0: A User Friendly Personal Computer Package for Flood and Drought Frequency Analyses
The use of personal computers have changed dramatically the way to perform several studies related with hydrological problems. The increased capabilities of the current generation of personal...
Dam Foundation Erosion Study: The Design of a Sidewall Orifice for Simulation of a Free Trajectory Overtopping Jet
This paper describes the design of a sidewall discharging orifice for simulation of a free trajectory overtopping jet. A sidewall orifice discharges through the sidewall of a pipe. The...
Return to search